This map shows the geographic areas for the north and south contour data. Use the map to determine the corresponding contour file to search and download.

Points representing waste water manholes. The manhole is an access point to pipes in sewage drains. Manholes are located at the beginning and end and at a change of direction or size of a waste water gravity pipe.

“The maps are provided for information purposes only and are not a replacement for contacting Alberta One Call”

This data represents the Airport Vicinity Protection Overlay (As described in Section 9.3 and Schedule C of the Land Use Bylaw 6-2015), the Heavy Industrial Transition Overlay (As described in Section 7.19 of the Land Use Bylaw 6-2015) the Highway Overlay (As described in Section 3.2.5 of the Land Use Bylaw 6-2015) and the Restricted Development Area (Alberta Infrastructure).

These are secondary land use guidelines for certain areas of Strathcona County. For further details about the Land Use Bylaw please refer to http://www.strathcona.ca/departments/planning-development-services/zoning-and-planning-documents/land-use-bylaw/

Strathcona County does not guarantee the currency, completeness or accuracy of this map and it is provided without warranty or condition of any kind.

A view of the population (male and female) based on the household census data aggregated to the enumeration area gathered in the 2012 Census.

These data represent the operational pressure zones used by Strathcona County utilities. These boundaries indicate the isolates areas within the water network, which are physically isolated by closed valves. Boundaries should be drawn through valves and along parcel lines to indicate which lots will be within a particular zone.

This data represents 1 metre contours in the southern portion of Strathcona County.

The 1 metre contour data was generated using the Digital Elevation Model (DEM) from the 2013 Orthophoto capture, which was based on the AltaliS 15 metre Lidar and the 1 metre lidar Strathcona County purchased. The 15 metre AltaLIS lidar has an accuracy of +/- 30 cm while the 1 metre lidar has an accuracy of +/- 15 cm. Because they are combined in the DEM, the accuracy varies depending on the coverage area.

Alberta 3TM Reference Meridian 114W

A chart showing the 0-4 population (male and female) based on the household census data aggregated to the enumeration area gathered in the 2012 Census.

This data represents the boundaries of the Council Approved Area Structure Plans and Area Redevelopment Plans. Some boundaries have been created by consolidating the approved Area Structure Plan and its subsequent amendments.

Within Strathcona County the Area Structure Plan (ASP) is defined as a 'statutory plans that outline development of a small part of a community or neighbourhood.'

Single line representation of 1 metre contours in the Northern portion of Strathcona County

Alberta 3TM Reference Meridian 114W

Data being provided is based on a valuation date of July 1, 2012 and a property condition date as of December 31, 2012. Strathcona County does not warrant, or guarantee the accuracy of this information. The County does not assume nor accept any liability from the use of the information. Data in this layer was produced based upon the 2014 Parcel Centroid Data.